At the end of the path…

Starts a new journey!

Over 100 parts were printed, cast, baked, polished and discarded…

Finally we got a result:

That was a long way!

I would also like to thank all those who have given me tips, offered help and provided me with their expertise! You are great!

What is next?

  1. Casing, deburring of many more cases and gluing with circuit board…
  2. Finalize the rest of the software…
  3. Bring the order page online for you!

At the same time, the engineer is working on the casting of the blueReader. There, too, was some progress in the method used. Now I’m waiting for the first colors and the ones with magnets!

My first “blue” blueReader I just wear with great pleasure. After a few minutes of the first wearing, it fell directly into the water … As promised, it does not matter to it, of course. Since then, I have been showering every day with this on the arm … Unfortunately, this also cost the life of a prototype, which was not in silicone and which I wore to the bridge the loading time…

The charging time is approximately 1.5 hours, if the blueReader is completely empty, until it is again at 100% battery.

Here are the first 17 modules, 15 of them with the production firmware (for testing the antenna and charging). Two were unfortunately not yet fully functional and have to be reworked.

Hopefully we can send the remaining 15 directly next week now (of course, finished and in silicone!) 🙂

This post is also available in: German